Configuring interfaces for Firewalls
The interface configuration process consists of several general steps.
The configuration proceeds as follows:
- Add the required number of network connections:
- Add physical interfaces.
- (Optional, Single Firewalls only) Add an ADSL interface for the integrated ADSL modem. Note: ADSL Interfaces are only supported on specific legacy Forcepoint NGFW appliances that have an integrated ADSL network interface card.
- (Optional, Single Firewalls only) Add a wireless interface for the integrated wireless router.
- (Optional, Single Firewalls only) Add modem interfaces for mobile broadband modem connections.
- (Optional, Single Firewalls only) Add a switch and port group interfaces for the integrated switch.
- (Optional, physical interfaces only) Add VLAN interfaces to physical interfaces.
- (Optional) Add tunnel interfaces for the route-based VPNs.
- (Not applicable to modem interfaces) Configure the IP address settings.
- (Optional) Add loopback IP addresses to assign IP addresses that do not belong to any directly connected networks to the firewall.
- Select the interfaces that are used for system communications.